Step 1: Preparing your materials
Prepare your work environment.
Organizing your tools and materials will help you work faster and more efficient.
Cut 4 pieces of light turquoise and 2 pieces of dark turquoise leather - 34cm long each.
Step 2 : Setting the stones
Place the stone in the center of the stone setting and with the help of the setting tool bend the prongs towards the stone in order to embed it.
Also set the 29ss stones in there stone settings.
Connect 6mm jump rings to all of the stone settings.
Step 3 : Connecting one side of the bracelet
Use one 3mm metal end for every pair if leather cords.
With the help of the plier tool press the metal end until it closes completely and holds the leather tightly.
Open 5mm jump rings and hang the leather cords on the big 8mm jump ring.
Use a plier tool to open the small loop on the clasp and connect it to the 8mm jump ring.
Step 4 : Sliding the stone setting on the leather
Slid the 37ss stone setting with tube on two leather cords, and the 29ss stone setting on one leather cord.
Slip the stone settings on every pair of leather cords.
After the bracelet is closed you can move the stone settings to there place.
Step 5 : closing the bracelet
Slide the metal ends on every pair of leather cords and close them.
Use 5mm jump rings to hang the leather cords on one 8mm jump ring, with an extension chain.
The bracelet is ready!
Enjoy your new beautiful Swarovski bracelet.