step 1: preparing your materials
Prepare your work environment. Organizing your tools and materials will help
you work faster and more efficient.
Cut the 3mm leather in to 92cm piece.
Also cut an extension chain of 5cm long.
Step 2 : placing the 12x12mm Square crimp setting
slip on the tube of the crimp element gently on the leather.
Slip all three of the elements and place them exactly in the middle of the leather cord, with 1cm space between them.
Now close the tube with the help of the pleir tool until its completely closed and holds the leather tightly.
Step 3: hanging the small pendents
we place 6mm jump rings on the leather, for the small pendents to hang from them.
Slide 3 jump rings on each side of the crimp element, that will be on the second and third row of the bracelet.
Open 6mm jump ring for each pendent and hang them with the help of the pleir tool on the jump ring that was slide on the leather.
Step 4: closing the bracelet
To close the bracelet two end of the leather needs to be held by the metal ends.
Us 6mm jump rings to connect the clasp and extension chain to the metal ends.
Now put the metal ends on the leather edge and use the pleir tool to press it until it closes.
Step 5: setting the stones
Place the stone in the center of the stone setting and with the help of the setting tool bend the prongs towards the stone in order to embed it.
Bend the prongs gently to make sure you don't damage the stone or crack the plating in this process.
To embed the small stones on the charms us E6000 glue and gently put them in place.
The bracelet is ready!
Enjoy your new beautiful Swarovski bracelet.